我昨天安装了GraphHopper的本地副本，但其结果与演示服务器不一致，特别是它通过标有bicycle=no:的部分进行路由
我的服务器（错误）：http://tile.miklcct.csproject.org:8989/?point=22.318106%2C114.162675&点＝22.317262%2C114.156554&车辆=自行车&locale=en-GB&高程=真&layer=MapQuest
演示服务器（右）：https://graphhopper.com/maps/?point=22.318106%2C114.162675&点＝22.317262%2C114.156554&车辆=自行车&locale=en-GB&高程=真&layer=MapQuest
config.properties
##### Vehicles #####
#
# Possible options: car,foot,bike,bike2,mtb,racingbike,motorcycle (comma separated)
# bike2 takes elevation data into account (like up-hill is slower than down-hill)
# and requires enabling graph.elevation.provider below
graph.flagEncoders=bike
# Enable turn restrictions for car or motorcycle.
# Currently you need to additionally set prepare.chWeighting=no before using this (see below and #270)
# graph.flagEncoders=car|turnCosts=true
##### Elevation #####
#
# To populate your graph with elevation data use SRTM, default is noop
graph.elevation.provider=srtm
#
# default location for cache is /tmp/srtm
# graph.elevation.cachedir=./srtmprovider/
#
# If you have a slow disk or plenty of RAM change the default MMAP to:
graph.elevation.dataaccess=RAM_STORE
##### Storage #####
#
# configure the memory access, use RAM_STORE for well equipped servers,
# MMAP_STORE_SYNC could be used otherwise but will be a lot slower
graph.dataaccess=RAM_STORE
# if you want to reduce storage size and you don't need instructions for the resulting path use:
# osmreader.instructions=false
#### Speed-up Mode vs. Flexibility Mode ####
#
# By default the speed-up mode with the 'fastest' weighting is used. Internally a graph preparation via
# contraction hierarchies is done to speed routing up. This requires more RAM/disc space for holding the
# graph but less for every request. Also only the first vehicle of the flagEncoders list will be prepared.
# prepare.chWeighting=fastest
#
# Disable the speed-up mode (contraction hierarchies, CH) via enabling the flexibility mode:
prepare.chWeighting=no
##### Web #####
# if you want to support jsonp response type you need to add it explicitely here. By default it is disabled for
# stronger security.
# web.jsonpAllowed=true
如何正确配置它以遵守限制？我正在使用最新的master分支。
我发现这不是graphhopper的问题。问题是我使用的数据源来自香港的"地铁摘录"，我已经用geofabrik.de的中国地图替换了它。问题已经解决。